Move on to the rear sway bar installation – Hotchkis 22400 Toyota Celica Sport Sway Bar Set User Manual
Page 6
12)
With all the hardware in place on the cradle you may torque everything down as per the diagram
shown here. Torque the four main cradle bolts to 116 ft/lbs. Torque the 3 bolts and 2 nuts
attached to the engine mount to 47 ft/lbs. Finally, torque the three front cradle to radiator
support bolts to 29 ft/lbs.
13)
Re-check all hardware for tightness. Use a jack to remove the jack stands and you’re ready to
move on to the rear sway bar!
IMPORTANT:
For proper maintenance the zerk fittings should be used to grease the sway bar
bushings at least once a year (15,000 miles) or whenever excessive noise occurs. Use a non-lithium
based grease only
! Lithium-based grease can wash out with water, and should not be used.
MOVE ON TO THE REAR SWAY BAR INSTALLATION