Hotchkis 22400 Toyota Celica Sport Sway Bar Set - Manual (Page 4)

8) Use the grease pack provided to apply a thick coat of grease to the inside of the new sway bar
bushing. Place the greased bushing over the sway bar with the split in the bushing towards the
front when installed in the vehicle. Slide the bushing retainer bracket over the bushing. Cover
the zerk fitting as shown with the attached plastic cap.
9) Lift the front sway bar into the stock position on the cradle. Route the bar over the hose as
shown. Use the stock hardware and a 12mm socket or wrench to hold the brackets in place on
the cradle. Torque the bracket hardware to 14 ft/lbs.
10) Re-attach the end links to the sway bar. Set the bar to the “soft” stiffness setting by using the
hole closest to the end of the bar while the “hard” stiffness setting is the farther hole from the
end of the bar. Use a 14mm wrench and 6mm Allen wrench to tighten the end links. Torque the
nut to 32 ft/lbs. If you purchased Hotchkis kit number #25400 (street end links), then you
should follow the instructions included with that kit at this time to replace your end links.