Hotchkis 22400 Toyota Celica Sport Sway Bar Set - Manual (Page 8)

3) Use a 14mm wrench and a 6mm Allen wrench to loosen and remove the rear end links from the
sway bar. Retain the hardware for later re-installation.
4) Use a 12mm socket or wrench to loosen and remove the bolts holding the stock sway bar in
place. Retain the hardware for later re-installation. The stock sway bar, bushings and brackets
can all be removed now and will not be used again.
5) Use the grease pack provided to apply a thick coat of grease to the inside of the bushing. Place
the bushing over the sway bar with the split in the bushing facing the rear of the vehicle when
installed. The bushings should be placed on the outside of the centering washers on the bar.
Place the bushing retainer bracket over the bushing.