Hotchkis 80413-1 350Z Stage 1 TVS Kit User Manual
Page 3
10)
At this point, we recommend
installing the FRONT endlink
into the hole that is FURTHEST
from the end of the bar. This is
the stiffest setting. Install the
nut and tighten down to 40 ft-
lbs as well. You can change
this setting later to fine tune the
handling of your car to your
personal taste.
11)
Reinstall the plastic undertray
using the stock hardware.
12)
After driving the vehicle, re-check all hardware for tightness. You are finished with the
front sway bar installation
IMPORTANT: For maintenance, you will have to remove and grease the bushings at least
once a year (15,000 miles) or when excessive noise occurs. Use a non-lithium based grease
only
! A lithium-based grease can wash out with water and should not be used.
MOVE ON TO THE REAR SWAY BAR INSTALLATION