Hotchkis 80413-1 350Z Stage 1 TVS Kit - Manual (Page 5)

7) Place the bushing over the Hotchkis bar in roughly the same location as the factory
installation Make sure you install the bushing so the split faces the front of the car once
installed in the car.
8)
Slip the bar into the car around the exhaust and install the endlinks into the end of the
bar to help hold it up.
9)
Install the Hotchkis brackets over the bushings and using the factory bolts, tighten the
bar to the frame. Torque these to 40 ft-lbs.