Hotchkis 80413-1 350Z Stage 1 TVS Kit - Manual (Page 6)

10) On the placement of the REAR endlinks, Hotchkis recommends installing the endlink
into the hole NEAREST the end of the bar. This is the lightest setting. The stiffness
can be adjusted at a later point to fine tune the car for your driving preference. Tighten
this to 40 ft-lbs as well.
11)
Replace the plastic trays.
12) Check that all hardware is tight. Use the caps provided to cover the zerk fittings and
you’re done installing the Hotchkis antiroll bar!
IMPORTANT: For maintenance, use the zerk fittings to grease the bushings at least once a
year (15,000 miles) or when excessive noise occurs. Use a non-lithium based grease only ! A
lithium-based grease can wash out with water and should not be used.
SEE NEXT PAGE FOR PARTS LIST