Hotchkis 22832R Audi RS4 Sport Rear Sway Bar User Manual
Page 3
7/
Repeat same pressure to the exhaust and position Hotchkis bar (without
the bushings and brackets) in the stock location with the Hotchkis sticker facing
rearward, right side up.
8/
Apply supplied grease to inner-channeled portion of both rear bushings.
(approx. half of one tube for rear bushings) Then install the bushings to the bar
at approx. the stock location. Position the bar in the stock location then install
the brackets over the bushings with the grease fittings pointing down.
9/
Re-install the four stock bracket bolts, include the four supplied
washers, to the new brackets and leave loose while you insert the small end link
sleeve to each end of the bar. Re-install the end link bolts and leave loose.
Tighten the four bracket bolts, then tighten the end links bolts. Six bolts, all tight.