Hotchkis 22832R Audi RS4 Sport Rear Sway Bar - Manual (Page 4)

*Adjustability Note: choose the inner hole (2
nd
aggressive feel and the outer for solid front-to-rear balance. Loosen the
lower end link bolts(2 under cast arm each side) on the bottom side of the
lower arm in order to adjust to desired hole.
from bar end) for a more
10/
Finally, re-attach exhaust hangers to the metal tabs on both sides.
YOU’RE DONE WITH THE REAR, NOW THE FRONT!!
1/ Drive the vehicle onto a 4-post lift or floor ramps. T HE CAR NEEDS TO BE AT
NORMAL RIDE HEIGHT FOR PROPER INSTALLATION . You cannot have the suspension
hanging while installing this bar!
2/
Once vehicle is raised, use a standard screwdriver and remove the aero-
pan fasteners. Then remove the pan entirely exposing the anti-roll bar.
3/
Take a moment and observe the stock front bar and the way in
which it is mounted.
4/
Remove the lower end link bolts (16mm wrench) to the bar and save.
Then, remove the four bracket nuts (13mm socket) and save. Remove the stock
bar.
5/
Apply second tube of grease to each inner-channeled portion of the two
new front bushings and attach to Hotchkis bar against the outside of the
washers. Slip the new brackets over the bushings.