Installation of hotchkis tuning rear sway bar – Hotchkis 80410-1 IS300 Stage 1 TVS Kit User Manual
Page 21
Please call us at (877) 4NO-ROLL if you have any questions regarding the service or installation
of your Hotchkis products.
• This installation will require:
Hydraulic jack, jack stands, torque wrench
The following wrenches or sockets: 12mm, 14mm
Allen wrenches or hex sockets: 5mm
INSTALLATION OF HOTCHKIS TUNING REAR SWAY BAR
1)
Securely block the front wheels of the vehicle. Use a jack to raise the rear end of the vehicle
and support it on jack stands.
2)
Observe the stock sway bar installation for reference.
3)
Use a 14mm wrench and 5mm Allen wrench to loosen and remove the end links from the sway
bar. Use a 12mm socket or wrench to loosen and remove the bolts holding the sway bar
bushing brackets. Retain all stock hardware. You may discard the stock sway bar, bushing, and
bushing retainer brackets.