Hotchkis 80410-1 IS300 Stage 1 TVS Kit - Manual (Page 8)

• This installation will require:
 A coil spring compressor, jack stands, floor jack.
 The following wrenches or sockets: 10mm, 12mm, 14mm, 17mm, 19MM
 The following alan wrenches or hex sockets: 6mm
 Torque wrench.
INSTALLATION OF REAR COIL SPRINGS
1)
Securely block the front wheels of the vehicle. Remove the trunk interior to gain access to the
upper shock mounts in the rear. Lift out the carpet and spare tire cover components. Use a
10mm socket or wrench to remove the four tie-down loops in the trunk.
Remove the trim clips indicated by the arrows. There should be four on each side with two along the
rear panel and two mounted just behind the fender well. Unscrew and remove the two plastic tie down
mounts located at the lip of the trunk. The interior panels should now be loose for removal.