Ohaus CT Series ELECTRONIC BALANCE - Manual (Page 49)

8
Power Options Power Options Power Options Power Options Power Options
The balance can be operated using 8 AA alkaline batteries (not included), or from any
AC electrical outlet by using the AC adapter supplied.
Battery Installation Battery Installation Battery Installation Battery Installation Battery Installation
1. Remove the platform on all models except the CT6000 (platform is not removable
on the CT6000).
2. Turn the balance over.
3. Press the tabs on the battery cover inward and lift the cover off.
4. Remove the battery holder.
5. Install the 8 AA alkaline batteries in the battery holder, orienting the plus (+) and
minus (-) ends as indicated on the holder.
6. Replace the battery holder in the compartment. Make sure the snap connector is
connected.
7. Replace the battery cover.
NOTE NOTE NOTE NOTE NOTE: The illustration shows a balance
with four feet. Certain models contain
only three feet.
Press tabs to
remove cover
AC Adapter AC Adapter AC Adapter AC Adapter AC Adapter
Plug the jack from the adapter into the
receptacle located on the right side of the
balance. Plug the adapter into a con-
venient AC outlet.