Ohaus CT Series ELECTRONIC BALANCE - Manual (Page 55)

14
NOTE NOTE NOTE NOTE NOTE: If PCErr is displayed, the sample is
too small to provide accurate results within
the selected parts counting error level (PC
Err of the Setup menu).
5. Add parts to the container as desired
and read the quantity on the display.
NOTE NOTE NOTE NOTE NOTE: The reference quantity will remain
in memory until it is changed or the bal-
ance is turned off.
6. To switch between viewing the quan-
tity and weight of the parts,
press .
(Example)
Printing Printing Printing Printing Printing
If the optional RS232 interface is installed,
display data can be output from the bal-
ance. The button operates in a
different manner depending upon if more
than one measuring unit is selected.
When only one measuring unit is en-
abled, a short press on will enable
printing when -P- is displayed. A long
press will turn the balance off. When
more than one measuring unit is enabled,
a short press on changes the mea-
suring unit, a one-second press will initate
printing, a long press will turn the balance
off. To print data, press and
hold until -P- is displayed, then
quickly release it.