Ohaus CT Series ELECTRONIC BALANCE - Manual (Page 85)

5
CONFIGURING THE PRINT MENU CONFIGURING THE PRINT MENU CONFIGURING THE PRINT MENU CONFIGURING THE PRINT MENU CONFIGURING THE PRINT MENU
The Print menu is used to configure the RS232 Interface parameters and customize
the balance’s print functions for your requirements. The following illustration shows
the sequence in which submenus appear on the Print menu.
PRINT MENU
RESET
YES/NO
BAUD RATE
300, 1200, 2400 2400 2400 2400 2400,
4800, 9600
DATA BITS**
7 7 7 7 7 or 8
PARITY BIT**
Odd, Even, None None None None None
STOP BITS**
1 or 2 2 2 2 2
AUTO PRINT
continuous, on stability,
OFF OFF OFF OFF OFF
STABLE DATA OUTPUT ONLY *
ON or OFF OFF OFF OFF OFF
END
Resets to original factory set-
tings:
Baud Rate: 2400
Data Bits: 7
Parity Bit: None
Stop Bit: 2
Auto Print: OFF
Stable Data Output
Only: OFF
Must be used to exit
and store changes
made.
* Not available on Legal for Trade models. Original factory settings apply.
**The total number of bits for Data, Parity and Stop must equal 9 or 10.
To access the Print menu, press and hold until Print appears, then release it.
Use these buttons to step through the menu and make selections:
select
displayed item
next
selection