Ohaus CT Series ELECTRONIC BALANCE - Manual (Page 54)

13
Parts Counting Parts Counting Parts Counting Parts Counting Parts Counting
Parts Counting must be enabled in the
Setup menu before using this procedure.
The balance will count parts based on the
weight of a reference sample, 5, 10, 20,
30, 40 or 50 parts. For optimum results,
the parts should be uniform in weight.
1. Repeatedly press until
PC
CON
is displayed.
2. Place a container on the platform,
then press . The balance dis-
plays
PC
ADD 5 which is the preset
reference quantity.
3. To change the reference quantity,
repeatedly press until the de-
sired quantity is displayed.
NOTE: NOTE: NOTE: NOTE: NOTE: If you need to exit or restart parts
counting at any time, press and hold
until
PC
CON is displayed, then release it.
Return to step 2 to restart, or press
for other weighing functions.
4. Add the displayed number of parts to
the container, then press . The
balance will display the current num-
ber of parts.
Parts Counting Factory Settings Parts Counting Factory Settings Parts Counting Factory Settings Parts Counting Factory Settings Parts Counting Factory Settings
Parts Counting Mode ........... Disabled
PC Err ......................................... OFF