Ohaus CT Series ELECTRONIC BALANCE - Manual (Page 66)

25
5. Set the value of all digits in the same
manner.
6. After the last digit is entered, the dis-
play will show the current exponent.
The exponent is shown on the display
preceded by the letter E.
There are 7 exponent values which you
can choose from (see table).
7. Press to change the exponent.
8. Press to accept the displayed
exponent. When is released,
the display will show the current least
significant digit.
The least significant digit is the digit in the
last decimal place on the display. The
selection you make causes the balance to
count by 1’s, 2’s or 5’s in this position.
There are 7 LSD settings you can choose
from (see table).
9. Press to change the LSD.
10. Press to accept the displayed
LSD. When is released, C.Unit
will be displayed again and the
Setup menu will be returned.
11. Proceed to the next item on the Setup
menu or use END to exit the Setup
menu and save your selections.
EXPONENTS EXPONENTS EXPONENTS EXPONENTS EXPONENTS
E-3 Moves decimal point 3
places to the left.
E-2 Moves decimal point 2
places to the left.
E-1 Moves decimal point 1
place to the left.
E0 E0 E0 E0 E0 Leaves decimal point in Leaves decimal point in Leaves decimal point in Leaves decimal point in Leaves decimal point in
normal position.
normal position. normal position. normal position. normal position.
E1 Moves decimal point 1
place to the right.
E2 Moves decimal point 2
places to the right.
E3 Moves decimal point 3
places to the right.
LSD’s LSD’s LSD’s LSD’s LSD’s
LSD .1 *Adds one decimal place
and Display counts by 1’s.
LSD .2 *Adds one decimal place
and Displayby counts by
2’s.
LSD.5 *Adds one decimal place
display counts by 5’s.
LSD 1 LSD 1 LSD 1 LSD 1 LSD 1 Display counts by 1’s. Display counts by 1’s. Display counts by 1’s. Display counts by 1’s. Display counts by 1’s.
(Normal Setting)
(Normal Setting) (Normal Setting) (Normal Setting) (Normal Setting)
LSD 2 Display counts by 2’s.
LSD 5 Display counts by 5’s.
LSD 10 Removes last decimal
place and Display counts
by 1’s.
* Sensitivity to vibration is increased
with this LSD setting.