Ohaus CT Series ELECTRONIC BALANCE - Manual (Page 69)

28
Stability Range Stability Range Stability Range Stability Range Stability Range
The stability range specifies how much a
displayed weight may change while the
stability indicator (unit indicator) remains
ON. When displayed weight changes
beyond the allowable range, the stability
indicator turns OFF indicating an unstable
condition. Portable
Advanced balances
permit you to select one of four stability
ranges (in divisions) as shown in the table.
NOTE NOTE NOTE NOTE NOTE: When the RS232 interface is
configured to print stable data only, the
stability range also governs data output.
Displayed data will only be output if it is
within the selected stability range.
To view or change the stability range:
1. Access the Stb submenu to display
the current setting.
2. Press to display the current set-
ting.
3. Press to change the setting.
4. Press to accept the displayed
setting, when released, Stb will be
displayed again.
STABILITY RANGE STABILITY RANGE STABILITY RANGE STABILITY RANGE STABILITY RANGE
.....5d Smallest range: stability indi-
cator is ON only when dis-
played weight is within .5 divi-
sions.
1d 1d 1d 1d 1d Normal range. Normal range. Normal range. Normal range. Normal range.
2d Increased range.
5d Largest range: stability indi-
cator is ON with displayed
weight changes up to 5 divi-
sions.