Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '06-07 For use with PowerPDA - Manual (Page 10)

10
96813 v.9.0
18.
Move the spare-tire to the rear
of the vehicle and center between
the dual tailpipes. Tighten the spare
tire with the manufacture tire tool
so that it is retained into place (See
Figure 5).
19.
Un-clip the axle vent hose outlet
attached to the bed near the spare
tire. Re-route the vent hose on top of
the fuel tank and attach to the bed.
Zip tie the vent hose and brake line
to the emergency brake cable, away
from the tailpipe.
20.
Adjust each of the pipes to
ensure that all of the hanger pins
are parallel with the frame-mounted
pins and fully inserted in the vehicle’s
rubber hangers.
21.
Be sure that the two (2) tailpipes
are completely engaged into the
Y-pipe. Rotate the tailpipe until the
hanger pins are parallel with the
frame-mounted pin.
NOTE: Recommended distance
between exhaust tip and body is a
half ( 1 ⁄ 2 ”) inch.
22.
Beginning with clamps closest
to the catalytic converter, and
working your way back, align the
saddle clamps to on the radius of
the corresponding pipe slots. Figure
3 illustrates the proper location of
an exhaust clamp on a tubing joint.
Evenly torque the nuts on each of the
exhaust clamps to 35 ft-lb.
Note: Whenever possible, tack
weld slip connections to prevent
disengagement is recommended.
23.
Remove the protective covering
from the tailpipe tip. Caution: the
protective covering may ignite
and burn if not removed prior to
running the engine.
-END, SEcTION 1-
BANKS
DRIVER SIDE
TAILPIPE
ZIP TIE ON
VENT HOSE
& BRAKE LINE
BANKS
PASSENGER SIDE
TAILPIPE
ADJUST SO THAT
SPARE TIRE TO
TAILPIPE CLEARANCE
IS THE SAME
MOVE SPARE
TIRE TOWARDS
REAR OF
VEHICLE
Figure 5