Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '06-07 For use with PowerPDA User Manual
Page 24
Advertising
24
96813 v.9.0
15.
In the engine compartment,
locate the BLAcK Ground wire with
the ring terminal on the EconoMind
Diesel Tuner wire harness. Install this
ring terminal onto the fender ground
stud, over the ring terminals already
there, and re-install the nut. See
Figure 29.
16.
connect the Red and Yellow
thermocouple wires on the
EconoMind wire harness with the
Red and Yellow lead wires on the
thermocouple.
Note: Go over the entire installation
as a precautionary check to ensure
that all clamps are tight, wiring
and hoses are properly routed, and
connections are correct and tight.
Make sure that the EconoMind wire
harness is not lying in the way of the
brake and gas pedals, or any moving
parts.
Figure 27
Advertising