Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '06-07 For use with PowerPDA User Manual
Page 20
20
96813 v.9.0
4.
Remove the electrical connector
bracket on the left hand side of the
support below the steering column in
front of the firewall by removing the
two (2) bolts. This will allow access
to the inner grommet. See Figure 20.
5.
cut the grommet on the firewall
inside the vehicle along the hole
created by the screwdriver in Step 2.
6.
Locate the in-cab cable with the
three connectors. From the engine
compartment, push the in-cab cable
through the hole cut in the firewall
grommet.
NOTE: Taping the end of the cable to
a piece of stiff wire (i.e. coat hanger)
may make routing the cable through
the firewall a simpler task. The stiff
wire should be pushed through the
slit in the grommet and then the
wires can be attached to the stiff
wire and pulled through the hole in
the grommet.
CAuTIoN: Pull gently to avoid
damage to the cable connectors.
Always pull on the cable sheath
rather than the wires themselves.
Figure 19
Figure 18
Figure 20