Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '06-07 For use with PowerPDA - Manual (Page 21)

96813 v.9.0
21
7.
From inside the vehicle, continue
to pull the in-cab cable through the
firewall until it is approximately 22”
inside the cab. Secure the cable
to the lower access panel area.
Take precaution to leave the three
connectors accessible for usage
further in the installation process.
8.
Locate the OBD II connector and
remove it from the sheet metal panel
by pressing the outer tabs in. Now,
push the connector out. See Figure
21.
9.
Locate the Banks OBDII Interface
cable and 11” cable tie in your kit.
connect the OBDII Interface cable to
the vehicle OBDII connector. Use the
11” cable tie as shown in Figure 22
to secure the Banks interface cable
to the vehicle OBDII connector. Now,
connect the 8-pin connector from the
Banks OBDII Interface cable to the
8-pin connector on the EconoMind
Tuner in-cab cable.
Note: If you are not installing the
optional Banks PowerPDA then coil
up and secure the cable with the
RJ12 (telephone style) connector end.
Figure 21
Figure 22