Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '06-07 For use with PowerPDA User Manual
Page 15
96813 v.9.0
15
39.
If your vehicle is NOT equipped
with a factory ground strap on the
intake heater, install the supplied
ground strap from the intake heater
to the engine. Put a 6-mm washer
onto the bottom intake heater
stud, leaving the factory heater nut
installed. Next, install the smaller
diameter ground strap terminal over
the stud and retain with a 6-mm
washer and nut. Route the other end
of the ground strap to the threaded
section on the engine and retain with
a SAE washer and M8- 1.25x 16 bolt.
See Figure 14.
40.
Slide the supplied intake gasket
over the four studs, then slide the
High-Ram over the studs.
41.
Install the supplied Stat-O-Seal
washers on the two driver side
(longer) studs. Driver side studs are
longer than passenger side studs.
The washers should be installed in
a twisting motion to prevent tearing
their sealing element. Install the
supplied
5
⁄
16
” flat washer on all
studs, then fasten with the supplied
5
⁄
16
-24 nylock nuts. The nuts should
be tightened to 12 ft-lbs (144 in-lbs).
An exploded view of the High-Ram
assembly is shown in Figure 15.
Figure 13. Orientation of the hose clamps on the driver side.
1
/
2
INTAKE HEATER
M6 NUT & M6
WASHERS (2)
M8 X 1.25 BOLT
SAE WASHER
LARGER
DIAMETER
TERMINAL
GROUND STRAP
FACTORY NUTS
Figure 14. High-Ram stud installation.