Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '06-07 For use with PowerPDA User Manual
Page 19
96813 v.9.0
19
1.
Place the EconoMind Diesel
Tuner box on top of the fuse box
located in the left front side in the
engine compartment. See Figure
18. The in-cab cable with the three
small connectors will be routed into
the cabin via the grommet on the
firewall. The other two harnesses
will be routed under the intake to
their respective locations listed in
the following steps.
2.
Locate the rubber grommet on
the drivers side firewall. Using a
utility knife, make a 1.5-inch-long
slit in the grommet next to the wire
harness. Be careful not to cut or
damage the harness. See Figure
19 for the proper location of the
required cut. Insert a screwdriver
from the engine compartment into
the cut hole and gently thrust it
through the grommet.
3.
Inside the vehicle, remove the
lower dash panel beneath the
steering column by removing the
two (2) screws at the bottom of
the panel. Retain the screws for
reinstallation.
NOTE: There are also two (2) clips
located at the top corners of the
panel, which hold the panel in place.
These clips can be released by gently
pulling on the corners of the panel.
Use caution to avoid damaging the
panel during removal.
Section 5
BANKS ECoNoMIND DIESEL TuNER INSTALLATIoN
Figure 17 EconoMind and supplied wiring harnesses