Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Tuner- Six-Gun Diesel Tuner & Banks Brake '08-10 For use with Six-Gun switch Only User Manual
Page 10
10
96511 v.7.0
Figure 5 Ford (08-09)
10.
Remove the bottom steering
column panel by pulling out to release
the retaining clip. See Figure 5.
Installing harness through firewall.
11
. Locate the rubber grommet on the
driver’s side of the vehicle firewall. The
grommet is about 3” in diameter. Make
a 1” x 1” cross-shaped (X) incision in
the grommet. Be careful so you do not
cut the factory harness.
12.
From inside the cab locate the
grommet on the firewall and make
another 1” x 1” cross-shaped (X)
incision on the grommet, opposite the
spot that was cut from the outside.
Now, feed the Six-Gun In-Cab cable on
the Turbo/In-cab harness through the
incision made in the firewall grommet
and into the cab See Figure 6.
Note: Some thick putty may be used
to provide additional sealing around
the In-Cab cable and the grommet.
If also installing Banks Brake wait
until after Section 2, step 5 to use
putty.
Mounting The Six-Gun Diesel Tuner
13.
If equipped, remove the vacuum
pump from its mounting location by
turning the thumb screw and lifting the
pump aside. See Figure 7.
14.
clean the area on top of the fuse
box cover.
Note: Make sure the entire mounting
surface is clean and free of dirt and
oil before mounting the Six-Gun Diesel
tuner. Clean and dry as required using
a cloth damped in rubbing alcohol or
similar cleaning solution.