Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Tuner- Six-Gun Diesel Tuner & Banks Brake '08-10 For use with Six-Gun switch Only - Manual (Page 30)

30
96511 v.7.0
If the Six-Gun Diesel Tuner has been
moved to a different vehicle, or you
are instructed to do so by Banks
Technical Staff, it is possible to reset
all of the parameters that the Six-Gun
has ‘learned’ - presence of an EGT
thermocouple or Speed-Loader, etc.
CAUTION: The following procedures
can only be carried out with the
engine OFF!
1.
Turn the vehicle key to ON but DO
NOT start the engine.
2.
Fully depress the throttle pedal and
then release it completely. Repeat 5
times. The GREEN LED will flash when
this is completed successfully.
3.
Turn the key OFF. Wait 30 seconds,
or until the GREEN LED goes off and
stays off. Turn the key back to the ON
position but DO NOT start the engine.
4.
Fully depress the throttle pedal and
then release it completely. Repeat 5
times.
-END, SECTION 8-
Section 8
CLEARING LEARNED INFORMATION
Section 9
REMOVAL OF THE SIx-GUN DIESEL TUNER
If the Six-Gun Diesel Tuner should ever
need to be removed from the vehicle,
perform the following:
Note: the ignition must remain in the
oFF position throughout the removal
process.
1.
Disconnect the Six-Gun’s PCM
connector from the left connection on
the PcM.
2.
Re-connect the vehicle’s PcM
connector back into the left
connection on the PcM.
3.
Disconnect the Six-Gun’s turbo
actuator connector from the vehicles
turbo actuator connection and
harness. Re-connect the vehicle’s
turbo actuator connector.
4.
Disconnect the 3 small connectors
on the ‘In-cab cable’ and gently pull
the cable back through the firewall.
5.
Remove the Six-Gun Diesel Tuner,
PcM harness and Turbo/In-cab harness
from the vehicle.
Failure to follow the above instructions
when removing the module will result
in a “check Engine” light on the dash
and a Diagnostic Trouble code being
stored in the factory computer, in
addition to the engine not running.
Note: Banks Brake will not function
without the Six-Gun tuner installed.
-END, SECTION 9-