Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Tuner- Six-Gun Diesel Tuner & Banks Brake '08-10 For use with Six-Gun switch Only User Manual
Page 17
96511 v.7.0
17
Figure 15 Banks Brake Module mounting location
15.
Locate the tow haul intercept
connector on the Banks Brake Wire
harness. Route the Tow Haul intercept
connectors under the dash towards
the front of the vehicle and up to the
top of the steering column following
the factory harness to the factory
tow haul connector. Make sure the
connectors and wires are free of
rotation from the steering column.
connect the female connector on
the Tow Haul intercept connectors to
the factory male tow haul connector.
connect the male connector on the
Tow Haul intercept connectors to the
factory female tow haul connector.
Secure the connectors and wires with
supplied cable ties.
16.
connect the Brake module 10-pin
connector on the Banks Brake wire
harness to the Brake module. The
connector will be the only one with a
label.
Note: Make sure the correct connection
is made to the tuner and the Banks
Brake before proceeding.
17.
Secure Brake Module under the
dash to any dash frame support or
main wiring harness using the supplied
cable ties. Use the cable tie support
loops on the side of the Brake Module
to securely fasten it under the dash.
See Figure 15.
Note: Make sure to mount the Brake
Module under the dash away from
moving parts and where it cannot
obstruct feet movement.
18.
Install the top steering column
panel back in place.
19.
Reinstall the factory screws to
fasten the steering column plans back
together.
20.
Go over all connections. Secure
the wire harness with the supplied ties
under the dash.
WARNING: Take care to keep any
cables away from the pedals
or where they could become
tangled.
-END, SECTION 2-