Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Tuner- Six-Gun Diesel Tuner & Banks Brake '08-10 For use with Six-Gun switch Only User Manual
Page 12
12
96511 v.7.0
Figure 8 Mounting location of Six-Gun tuner to Fuse box, driver
side.
15.
Locate the two (2) dual-lock
fasteners in your kit. Peel the protective
backing off from one side of the hook
and loop interlocking fasteners and
attach to the recess area on the back of
the tuner module.
16.
Peel the protective backing off
the other side of the hook and loop
interlocking fasteners on the back of
the tuner module and affix the tuner to
the top of the fuse box cover as shown
in Figure 8. Apply light pressure to the
Six-Gun Diesel Tuner module by hand
for 60 seconds to create a strong bond
between the fuse box and hook & loop
interlocking fasteners.
17.
connect the PcM and Turbo/
In-cab harness connectors to the
correct Six-Gun module connection. The
connections are keyed differently so
make sure to connect the correct one
into the appropriate connection. See
Figure 8.
18.
If previously removed, reinstall
the Vacuum Pump in place and secure
with the factory thumb screw.
19.
Go over all connections. check all
connections under the hood and keep
wires away from heat sources when
possible.
END, SECTION 1-