Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Tuner- Six-Gun Diesel Tuner & Banks Brake '08-10 For use with Six-Gun switch Only User Manual
Page 7
Advertising
96511 v.7.0
7
Section 1
INSTALLATION OF BANkS SIx-GUN WIRE HARNESS
Figure 1: Banks Six-Gun and supplied wiring harness
If you have previously installed a
Six-Gun and are adding the Banks
Brake, Skip to Section 2.
If you are installing the Banks Six-
Gun for the first time, continue to
Step 1.
Six-Gun Installation
1.
Locate the Six-Gun Powertrain
control Module (PcM) Harness. See
Figure 1. Place harness over the
driver side fuse box. Route the PCM
connectors from the driver side fuse
box along the rail on the rear of the
engine compartment to the passenger
side of the vehicle. See Figure 2.
Advertising