Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Tuner- Six-Gun Diesel Tuner & Banks Brake '08-10 For use with Six-Gun switch Only User Manual
Page 20
20
96511 v.7.0
8.
Align the Banks Six-Gun and Brake
label on the previously drilled holes
on the front of the dash panel. Make
sure the entire mounting surface is
clean and free of dirt and oil before
mounting the label. clean and dry as
required using a cloth damped with
rubbing alcohol of similar cleaning
solution. Remove the adhesive
backing and affix the label to the dash
panel. Hold the labels against the
panel for approximately 20 seconds
while applying pressure to allow the
adhesive to properly adhere to the
surface.
9.
Rotate the switches
counterclockwise until the shaft stops.
Verify that the Six-Gun washer tab
is inserted into the #6 position and
that the Brake washer tab is inserted
into the #5 position on the switch as
shown in Figure 20.
Note: All of the Six-Gun and Brake
settings may not be usable if the tabs
are not inserted into the proper position.
10.
Install the switch through the
13
⁄
32
” hole on the backside of the
bezel. The alignment pin should rest
in the
1
⁄
8
” hole and the switch fully
rotated counterclockwise. Secure the
switch with the internal tooth washer
and nut. Snug the nut. Be careful not
to over-torque the nut and damage the
threads.
11.
Install the knob on the shaft
facing the “OFF” setting for the Banks
Brake and the “1” setting for the Six-
Gun. On the knob, snug the two (2) set
screws with the supplied 0.050” hex
key wrench. The completed switch
installation will appear as shown in
Figure 21.
If not installing the optional Banks
Brake, skip step 12.
12.
Route the RJ12 connector (phone
like connector) to the Banks Brake
switch cable connector, and plug the
connectors. Secure all loose wiring
under the dash with supplied cable
ties.
13.
Re-install the instrument cluster,
make all electrical connections that
were disconnected, and secure with
the factory screws.
14.
Re-install the Center Finish Panel,
make all electrical connections that
were disconnected, and secure with
the factory screws.
Figure 19 Remove the plastic around the top hole for switch placement