Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner (235, 250, 305, 325 HP Dodge 5.9L Cummins (24-valve) Trucks) '03-05 Compatible with Optional PowerPDA - Manual (Page 15)

96807 v.9.0
15
NOTE: Go over the entire installation as
a precautionary check to ensure that
all clamps are tight, wiring and hoses
are properly routed, and connections
are correct and tight. Make sure that
the Six-Gun wire harness is not lying in
the way of the brake and gas pedals,
or any moving parts.
17.
(Engine compartment) After
confirming all of the system connections
are correct, make sure the entire
mounting surface is clean and free of
dirt and oil before mounting the Six-
Gun Diesel Tuner. Clean and dry as
required using a cloth dampened with
rubbing alcohol or a similar cleaning
solution.
CAUTION: Do not spray fluid
directly onto any electrical
equipment, or equipment damage
may result. Mount the Six-Gun
Diesel Tuner on the top of the fuse
box cover as shown in Figure 2, by
peeling the protective backing off
the adhesive tape on the back of
the Six-Gun Diesel Tuner.
18.
Hold the Six-Gun Tuner against
the fuse box cover for approximately
1 minute while applying pressure to
allow the adhesive to properly adhere
to the surface.
-END, SECTION 1-
Figure 13