Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner (235, 250, 305, 325 HP Dodge 5.9L Cummins (24-valve) Trucks) '03-05 Compatible with Optional PowerPDA - Manual (Page 19)

96807 v.9.0
19
11.
Route the RJ12 cable through
the opening and connect it to the left
most receptacle on the bottom of the
Docking Station. Replace the dash
plate and screw.
WARNING: THE CHARGING CABLE
ON THE DOCKING STATION
IS DESIGNED TO SUPPLY A
CONSTANT LOW-VOLTAGE POWER
SOURCE (+5VDC) TO THE BANKS
POWERPDA AND IS “LIVE” AS
LONG AS THE SYSTEM’S OBD II
INTERFACE CABLE IS COMPLETELY
INSTALLED AND THE RJ12
CONNECTOR IS PLUGGED INTO
THE DOCKING STATION.
ALTHOUGH THIS CHARGING CABLE
IS SHORT AND ITS CIRCUITRY IS
FUSE-PROTECTED, THE USER IS
EXPECTED TO TAKE APPROPRIATE
MEASURES TO PREVENT SMALL
CHILDREN AND/OR PETS FROM
CONTACT WITH ANY PART OF THIS
SYSTEM.
12.
Re-install the electric connector
bracket that was removed in Step 5 of
Section 1, below the steering column
in the front of the firewall with the
original two (2) bolts.
Route all wiring away from any pedals
or other moving components. Using
the cable ties supplied, secure the
wiring under the dash. Secure all
wiring under the hood away from heat
sources or sharp edges. Re-install the
lower dash panel with the original 2
bolts. (See Figure 20)
13.
Your Docking Station is now
installed and is ready for the
Banks PowerPDA. Install the Banks
PowerPDA into the Docking Station.
Be sure the Banks PowerPDA is
completely seated in the Docking
Station against the lower support
bracket.
14.
Plug the Docking Station’s
charging cable into the charging
receptacle on the lower edge of the
Banks PowerPDA.
NOTE: There may be a snug fit when
installing the Banks PowerPDA into the
Docking Station. Take care not to force
this process.
15.
Re-install all remaining dash
components
-END, SECTION 2-