Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner (235, 250, 305, 325 HP Dodge 5.9L Cummins (24-valve) Trucks) '03-05 Compatible with Optional PowerPDA - Manual (Page 23)

96807 v.9.0
23
10.
Install the knob onto the shaft
facing the #1 Level on the Six-Gun
label. On the knob, snug the two (2)
set screws with the supplied 0.050”
hex key wrench.
11.
Reinstall the cluster bezel by
pressing on it to ensure all the
clips are engaged. Secure it with the
original a two (2) screws.
12.
Reconnect the electrical
connector to the headlamp switch
bezel. Reinstall this bezel by gently
pushing on it until all clips are
engaged.
13.
Reconnect the four (4) electrical
connections to the center bezel.
Reinstall this bezel by pushing on
it to engage all the clips. Open the
ashtray and cup holder and reinstall
the original screw.
14.
Route the Six-Gun switch wires
down to the steering column.
15.
Route the Six-Gun switch’s cable
to the wire harness that was routed
into the passenger compartment from
the Six-Gun module, and plug the 2-pin
connector into the corresponding
connector on the Six-Gun harness.
16.
Re-install the electric connector
bracket that was removed in Step 5 of
Section 1 below the steering column
in the front of the firewall with the
original two (2) bolts.
17.
Route all wiring away from any
pedals or other moving components.
Using the cable ties supplied, secure
the wiring under the dash. Secure all
wiring under the hood away from heat
sources or sharp edges. Re-install the
lower dash panel with the original 2
bolts.
-END, SECTION 3-