Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner (235, 250, 305, 325 HP Dodge 5.9L Cummins (24-valve) Trucks) '03-05 Compatible with Optional PowerPDA - Manual (Page 9)

96807 v.9.0
9
5.
Remove the electrical connector
bracket on the left hand side of the
support below the steering column in
front of the firewall by removing the
two (2) bolts. This will allow access to
the inner grommet. See Figure 4.
6.
cut the grommet on the firewall
inside the vehicle along the hole
created by the screwdriver in Step 3.
7.
Locate the in-cab cable with the
three connectors. From the engine
compartment, push the in-cab cable
through the hole cut in the firewall
grommet.
NOTE: Taping the end of the cable to
a piece of stiff wire (i.e. coat hanger)
may make routing the cable through
the firewall a simpler task. The stiff
wire should be pushed through the slit
in the grommet and then the wires can
be attached to the stiff wire and pulled
through the hole in the grommet.
CAUTION: Pull gently to avoid
damage to the cable connectors.
Always pull on the cable sheath
rather than the wires themselves.
8.
From inside the vehicle, continue
to pull the in-cab cable through the
firewall until it is approximately 22”
inside the cab. Secure the cable
to the lower access panel area.
Take precaution to leave the three
connectors accessible for usage
further in the installation process.
9.
Locate the Banks OBDII Interface
Cable and 11” cable tie in your kit.
connect the OBDII Interface cable to
the vehicle OBDII connector. Use the
11” cable tie as shown in Figure 5
to secure the Banks interface cable
to the vehicle OBDII connector. Now,
connect the 8-pin connector from the
Banks OBDII Interface cable to the
8-pin connector on the Six-Gun Tuner
in-cab cable.
Figure 4