Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner (235, 250, 305, 325 HP Dodge 5.9L Cummins (24-valve) Trucks) '03-05 Compatible with Optional PowerPDA - Manual (Page 7)

96807 v.9.0
7
Section 1
INSTALLATION OF WIRING HARNESS, CONNECTIONS AND SIx-GUN
DIESEL TUNER
1.
Disconnect the battery ground
cables from each of the batteries.
Secure the cables so that they do not
come in contact with the batttery
posts during the installation.
2.
Place the Six-Gun Diesel Tuner
box on top of the fuse box located
in the left front side in the engine
compartment. See Figure 2. The
in-cab cable with the three small
connectors will be routed into the
cabin via the grommet on the firewall.
The other two harnesses will be routed
under the intake to their prospective
locations listed in the following steps.
3.
Locate the rubber grommet on the
drivers side firewall. Using a utility
knife, make a 1.5-inch-long slit in the
grommet next to the wire harness.
Be careful not to cut or damage
the harness. See Figure 3 for the
proper location of the required cut.
Insert a screwdriver from the engine
compartment into the cut hole and
gently thrust it through the grommet.
4.
Inside the vehicle, remove the
lower dash panel beneath the steering
column by removing the two (2)
screws at the bottom of the panel.
Retain the screws for re-installation.
NOTE: There are also two (2) clips
located at the top corners of the
panel, which hold the panel in place.
These clips can be released by gently
pulling on the corners of the panel.
Use caution to avoid damaging the
panel during removal.
Figure 1 Six-Gun and supplied wiring harnesses