Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-970 - Manual (Page 21)

PNEG-970 S2 Hopper w/ Collector Ring 21
Assembly
3. ASSEMBLE THE CROSSBRACE TO THE HOPPER
A. Feed the multi-conductor cord through the collector ring shield, lower tube assembly, and
drilled hole in hopper side.
B. Bolt the collector ring shield to the crossbrace assembly using sixteen (16) 1/4"-20 x 1" hex
bolts, flat washers, lock washers, and hex nuts.
C. Slide the lower tube assembly into the shield assembly.
1/4"-20 x 1" hex bolt
hex nut
lock washer
crossbrace
assembly
collector ring shield
lower tube
assembly
multi-conductor
cord
hopper
flat washer