Assembly – Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-970 User Manual
Page 22
Advertising
PNEG-970 S2 Hopper w/ Collector Ring
22
Assembly
3. ASSEMBLE THE CROSSBRACE TO THE HOPPER (cont.)
D. Making sure the lower tube assembly and drilled hole are aligned, bolt the crossbrace to the
hopper using eight (8) 1/2"-13 x 1 3/4" hex bolts, flat washers, lock washers, and hex nuts.
E.
Attach the 1" liquid-tight flex conduit coupling on the conduit assembly to the hopper.
F.
Slide the lower tube weldment against the hopper and tack weld into position.
1/2"-13 x 1 3/4"
hex bolt
hex nut
lock washer
crossbrace
assembly
hopper
Advertising