Grain Systems PNEG-349 - Manual (Page 10)

10
Service Platform & Stiffener PLATFORM INSTALLATION
7. Use two flathead allen capscrews
and connect the center floor
support, D61-0062, to the front
and main support channels.
8. Use a carpenter square and
check the squareness of the as-
sembled unit, between the main
channel and the side channels.
If necessary, shift the position
of the main channel slightly, us-
ing the slotted attaching holes,
until the unit is properly
squared. Then fully tighten all
channel bolts.
Figure 9: Center floor support placement.
Figure 10: Check for square and tighten bolts.