Grain Systems PNEG-349 - Manual (Page 12)

12
Service Platform & Stiffener PLATFORM INSTALLATION
Inner Guard Rail
Install the inner guard rail supports
and related parts within platform
package number two as follows:
1. Connect the right-hand rear in-
ner guard rail support angle (D01-
2041). Use 5/16" x 3/4" bolts.
2. Use 5/16" x 3/4" bolts and con-
nect the left-hand inner guard
rail support angle (D01-2042).
3. Connect a lower inner guard rail
angle on each side (D01-2043).
Outer Guard Rail
Supports
Install outer guard rail support chan-
nels, door hinge channel and floor
panels contained within platform
package number two and number
three as follows:
1. Use 5/16" x 3/4" bolts and loosely
connect the seven guard rail
support channels (D61-0037) to
the platform support channels.
2. Connect the outer door hinge
channel (D61-0066) using 5/16"
x 3/4" bolts.
Figure 14: Install remaining support channels.
Figure 13: Location of inner guard rail support angles.
D01-2042
D01-2043