Grain Systems PNEG-1935 - Manual (Page 34)

5. Operations
34 PNEG-1935 Vision Hybrid for Portable Dryers
Select Data Log Sample Time
Notice the “Sample Time” button in the upper left hand side of the dryer status chart. By touching this
button, the sample time can be changed from the default (1 minute) to 5, 10 or 15 minutes. Select the
desired sample time and touch “Accept/Exit” to exit. Also, notice that the chart can be cleared by selecting
the “Clear Table” button at the bottom.
(See Figure 5V.)
Figure 5V
2. Graph View: This is the “Optional Operation Screen”. (See Figure 5W.)
Figure 5W
To initiate this option, press the “Graph View” button, then touch the “Exit” button. Notice that the
Dryer Status Chart and Plenum(s) sections have been replaced by the graph view. You can choose
what the graph will display by touching any of the colored buttons under the graph (i.e. moisture in,
moisture out, dryer temperature, grain temperature in, grain temperature out and meter rolls).
Touching these buttons once will display them on the graph and touching them again will remove
them. The “Setup” button will bring up the “Graph Setup” window and allow you to choose the length
of time (1, 2, 4 or 8 hours) for the horizontal scale.