Grain Systems PNEG-1935 - Manual (Page 37)

5. Operations
PNEG-1935 Vision Hybrid for Portable Dryers 37
Modifying Moisture Setpoint
Figure 5AA
Resetting Factory Defaults
If the Vision system starts malfunctioning, sometimes restoring the factory defaults will alleviate
the problem.
NOTE: This will completely change the system setup, so this procedure is encouraged to be performed
by a service technician.
1. Turn control power “OFF”.
2. Locate the “DEF” dipswitch on the Display I/O board.
3. Push the switch to the left.
4. Turn control power “ON” and make sure the red light next to the “DEF” switch is lit.
5. At the “Boot Screen”, press “Start Dryer”.
6. Once a message appears instructing you to push the switch back to the left, the setting has
been reset.
7. Turn control power “OFF”.
8. Push the “DEF” dipswitch to the right.
9. The Vision system is now ready to operate normally.