Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1597 - Manual (Page 11)

PNEG-1597 Sweep Tractor and Control Panel Assembly Instructions 11
4. Assembly
Sweep Tractor Assembly
1. Place the tractor frame on plain flat ground.
2. Bolt each pillow block bearing to a bearing mount bracket using two (2) 1/2"-13 x 2" hex head
cap screws, two (2) flat washers and serrated flanged nuts.
3. Bolt each bearing mount bracket to the tractor frame using two (2) 1/2"-13 x 1-1/4" flange bolts and
serrated flanged nuts. (See Figure 4A.)
NOTE: Lock collar flanges for each pillow block bearing must be to the inside of frame.
Figure 4A