Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1597 - Manual (Page 22)

4. Assembly
22 PNEG-1597 Sweep Tractor and Control Panel Assembly Instructions
Sweep Tractor to Shield Assembly
1. Position sweep tractor against the sweep shield approximately 3' from the end wheel.
2. Use the bracket on the sweep tractor to mark the location where the holes need to be drilled into the
sweep shield.
3. The bolts that attach the sweep bracket to the tractor frame may need to be adjusted so that height
and angle of the sweep back shield and the shield bracket are matched.
4. After marking the hole locations, drill six (6) 7/16" holes and attach the sweep tractor to the back
shield using six (6) 3/8" x 1" hex head cap screws, flat washers and nylock nuts.
5. Install electric wiring for motor and controls. (See Figure 4M.)
Figure 4M Sweep Tractor to Shield Assembly
CAUTION
All electrical wiring shall be installed by a qualified electrician and must meet the
standards set by the National Electric Code and all local and state codes.