Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1597 - Manual (Page 21)

4. Assembly
PNEG-1597 Sweep Tractor and Control Panel Assembly Instructions 21
End Wheel Assembly
NOTE: If installing sweep tractor to an existing sweep, the current end wheel components must
be removed.
1. Connect the stub shaft into the sweep flight using a 5/8"-11 x 4" hex head cap screw and
5/8" stover nut.
2. Install the bearing stand assembly onto the stub shaft and bolt it to the sweep shield using two (2)
3/8" x 3" carriage bolts, flat washers and nylock nuts.
3. Install the end wheel and collar onto the end of the stub shaft. Pin the collar in place with a
1/2" x 3-1/2" hex head cap screw and prevailing torque lock nut. (See Figure 4L.)
Figure 4L End Wheel Assembly