Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1597 - Manual (Page 20)

4. Assembly
20 PNEG-1597 Sweep Tractor and Control Panel Assembly Instructions
21. Mount the weights to the weight stand using one 5/8"-11 x 8-1/2" threaded rod and three (3) flange
nuts and one flat washer. (See Figure 4K.)
NOTE: Install the weights against the left hand of the weight stand so the weight is in the middle of
the tractor assembly. The weight stand can be reversed so that the weights hang over the
front of the frame, if necessary. Adjust the weights to the inside of the frame to center the
weight on the frame when the weight stand is reversed as described above.
Figure 4K