Grain Systems PNEG-1702 - Manual (Page 41)

6. Competitor/Dri-Tek Test Firing
PNEG-1702 ETL Listed GSI/FFI Portable Dryer Manual 41
Set Control Switches
Moisture Control Switch OFF
Moisture Control Thermostat 200°
Load Switch OFF
Unload Switch OFF
Fan Switch OFF
Burner Switch OFF
Out of Grain Timer 1 MINUTE (Reset to 8 Minutes after testing)
Load Delay 30 SECONDS
Unload Delay 30 SECONDS
Metering Roll Speed LOW AND HIGH SPEED SETTINGS PUT ON ZERO
Dry Timer 60 MINUTES
Cool Timer 20 MINUTES
Unload Timer 10 MINUTES
Mode Switch CONTINUOUS FLOW
Electrical Power
Turn ON the electrical power supply to the dryer. Set all circuit breakers to ON, including the safety
disconnect handle mounted on front of the dryer’s power panel.
Control Power Switch
Turn the Control Power switch to ON. The switch light comes on. “GSI” and the software version will
appear. At this point, the controller will lock out all other dryer functions and the dryer will perform its safety
circuit check. If a fault is found, the cause will be displayed on the LCD. If all safeties are safe, the controller
will supply power to the electronic fuel shut off valve (if so equipped). Press the Start button to initialize
the computer.
Power Start Button
Push the Start button and all the toggle switches on the control panel will be activated. This initializes the
load, fan, burner, unload and metering rolls individually.
Fuel Check
If using LP gas, make sure the tank has plenty of fuel and that the TANK DOES NOT HAVE A PRESSURE
REGULATOR MOUNTED TO IT. If using natural gas, make sure an adequate supply is available.
If using LP gas, slowly open the main fuel supply valve at the tank. If using natural gas, turn ON the
valve along the supply line. Then, open the manual shut off valve on the dryer to allow fuel flow to the
dryer. Inspect all gas lines and connections for possible leaks. ANY GAS LEAKS NEED TO BE
FIXED IMMEDIATELY.