Warning, Vehicle seat belts – BabyTrend FB60408 - TRENDZ FASTBACK 3-IN-1 CAR SEAT - JELLY BEAN User Manual
Page 16
29
30
9.2 Locking Clip Installation
WARNING
DO NOT USE LOCKING CLIP IN BOOSTER SEAT MODE.
Locking Clip is located in the pocket on underside
of Seat Pad. (Fig 30-1)
1. Tighten the buckled seat belt around the Car
Seat by pulling upward on the shoulder belt
while pushing down hard on the Car Seat.
2. While maintaining downward pressure
on the Car Seat, squeeze the shoulder
belt and lap belt together just above the
buckle to prevent it from moving. Unbuckle
the seat belt, being careful to prevent
movement of the buckle.
3. Secure the shoulder belt to the lap belt
by installing the Locking Clip 1/2” from
the buckle. (Fig 30-2)
4. Re-buckle the seat belt and check that the
seat belt is very tight around the Car Seat.
Pull firmly on the lap belt to ensure that
the Locking Clip is locking the lap belt and
remains very tight.
Test installation to make sure Car Seat is secure.
If NOT secure, additional belt tightening is
required. Repeat steps above until secure.
9.0
Vehicle Seat Belts
9.0
Vehicle Seat Belts
is suitable for use with the Car Seat.
Once this type of seat belt is fastened,
the latch plate prevents the lap belt from
loosening. This combination seat belt
does not require a Locking Clip. (Fig 29-1)
Note: The belt is tightened by pulling
hard on the shoulder belt while pushing
down hard on the Car Seat.
Combination Lap/Shoulder Belt with Sliding
Latch Plate
A lap/shoulder combination belt system with
a latch plate that can slide freely along the
belt (Fig 29-2) is suitable for use with the
Car Seat if it includes a lockable retractor or
a Locking Clip (Fig 29-3) MUST be used to
secure the lap belt into position to prevent
loosening Use the Locking Clip provided with
the Car Seat as instructed (See section 9.2).
Please refer to your vehicle owner’s manual for additional
information on locking this style of seat belt. This style of
belt MUST be locked to prevent movement of the Car Seat.
Locking clip
29-2
29-3
1/2” (1.25cm)
30-2
30-1
29-1