BabyTrend FB60408 - TRENDZ FASTBACK 3-IN-1 CAR SEAT - JELLY BEAN - Manual (Page 38)

73 74
13.0
Securing Backless Booster Seat in Vehicle
13.0
Securing Backless Booster Seat in Vehicle
13.6 Using Shoulder Belt Positioning Clip
Use the Shoulder Belt Positioning Clip (Fig 74-1)
to center the vehicle shoulder belt on the child’s
shoulder. Shoulder belt MUST be centered
on child’s shoulder as shown. (Fig 74-2)
Attaching the Shoulder Belt Positioning
Clip to backless booster:
1. Unhook elastic loops at the back of the
Seat Pad and lift the Seat Pad up. Set
aside the Harness Adjuster Strap and
lift open the hatch. (Fig 74-3)
2. Lay Shoulder Positioning Belt Clip out on
flat surface with free end on top.
3. Thread the loop end of the strap through the
slot on the rear of the booster seat.
(Fig 74-4)
6. Position the lap/shoulder belt so that it lies
across the child’s shoulders as shown.
(Fig 73-1) If the vehicle shoulder belt
does not lie across the child’s shoulder as
shown, the Shoulder Belt Positioning Clip
MUST be used. See Section 13.6 Using
Shoulder Belt Positioning Clip.
7. Check fit of the vehicle seat belts on child:
- Vehicle lap belt must be low on
hips contacting the thighs.
- Vehicle shoulder belt must contact the chest
and be centered on the shoulder. Use the
shoulder belt positioner clip to adjust the
position of the vehicle shoulder belt.
- DO NOT place vehicle shoulder belt
under child’s arm or behind child.
IMPORTANT: The booster seat should not move more than one 1” (2.5
cm) side-to-side or back and forth. If booster seat is not secure, repeat
the installation procedure or find another seat location for the booster
seat. (See Section 8.0 Selecting the Best Vehicle Seat Location)
74-1
Free end
Hatch
Seat pad
Loop end
74-2
74-3
74-4
73-1