Warning, Securing toddler seat in your vehicle – BabyTrend FB60408 - TRENDZ FASTBACK 3-IN-1 CAR SEAT - JELLY BEAN User Manual

Page 18

Advertising
background image

33

34

Only use the car seat LATCH System in vehicle seating

positions designated by the vehicle manufacturer as LATCH

use position and have anchor spacing of 11 inches (280 mm).

The car seat must be held tightly by the LATCH System.
Never attach more than one top tether hook to a vehicle

anchorage unless recommended in the vehicle owner’s manual.

Your child restraint can be installed with either LATCH or with a

SAFE vehicle belt system. To properly install the child restraint and

protect your child, you must carefully follow these instructions.

10.1 Installation with LATCH System

The LATCH system is made up of the two lower

child restraint anchorages and a top tether anchor

anchorage. When available, LATCH is the recommended

method of securing the Car Seat in the vehicle.

• Locate a LATCH seating position and locate the LATCH anchorages in

the vehicle seat. (See Section 7.0 LATCH for more information)

The LATCH System when used with top tether, may be used to 50

lbs (23 kg). Over 50 lbs (23 kg), disconnect LATCH and secure with a

vehicle seat belt.

• If vehicle seat back is adjustable, adjust into the upright position or the

position or the position specified in the vehicle owner’s manual for use

with a Car Seat.

INSTALLATION WITH BUILT-IN HARNESS

WARNING!

DEATH or SERIOUS INJURY can occur:

FAILURE TO PROPERLY SECURE THE CHILD RESTRAINT IN

YOUR VEHICLE INCREASES THE RISK OF SERIOUS INJURY OR

DEATH IN THE EVENT OF A SUDDEN STOP, SHARP TURN OR

CRASH.

Proper installation is required.
The belt routing for securing this Car Seat in a vehicle is

dependent on installation WITH or WITHOUT the Top Tether.

Secure this child restraint with LATCH System or vehicle

seat belt and Top Tether Strap as shown in this manual.

LATCH or vehicle seat belt must stay tightly

adjusted around Car Seat at all times.

Vehicle seat belt must be routed through Back

Support of Car Seat when using harness system.

Snugly adjust harness provided with the Car Seat around child.
Harness straps must be through harness strap

slots at or above child’s shoulders.

Never place vehicle seat belt in front of

child when using harness system.

10.0

Securing Toddler Seat in Your Vehicle

10.0

Securing Toddler Seat in Your Vehicle

Advertising