BabyTrend FB60408 - TRENDZ FASTBACK 3-IN-1 CAR SEAT - JELLY BEAN - Manual (Page 24)

45 46
11.0
Securing Child with Built-in Safety Harness
11.0
Securing Child with Built-in Safety Harness
2. Open Harness Clip by pressing button and
sliding apart. (Fig 46-1)
3. Unbuckle Harness Buckle by pressing
button. (Fig 46-2)
4. Place child in seat with child’s back
contacting Back Support and rump
contacting seating surface.
5. Check that harness slots are at or above
the child’s shoulders. Adjust the seat back if
necessary. (Fig 46-3)
6. Place Built-in Safety Harness over child’s
shoulders and insert both buckle tongues
into the Harness Buckle until they click into
place.
Note: Make sure that BOTH tongues click
into place. (Fig 46-4)
• Do not use Car Seat with harness straps loose or unbuckled.
Harness straps MUST be snug and positioned over shoulders
and thighs of child.
In a crash, the Car Seat provides NO protection for your child unless
the harness straps are properly secured and installed according to
these instructions. Make sure that the harness straps are properly
adjusted and secured whenever using the Car Seat.
IMPORTANT: Adjust the harness snugly every time you place
your child in the Car Seat and AVOID bulky clothing.
We recommend using the built-in safety harness for as long as possible
before changing to the high back booster mode.
Both the harness height and crotch belt length are adjustable. Always
properly adjust to fit your child as indicated in this section.
1. Loosen built-in safety harness by
pressing the Harness Adjuster Button
and pulling the harness assembly
toward you. (Fig 45-1)
46-3
45-1 46-4
46-2
46-1