BabyTrend FB60408 - TRENDZ FASTBACK 3-IN-1 CAR SEAT - JELLY BEAN - Manual (Page 25)

47 48
7. Check buckle height. If buckle is too low
or to high, adjust height. (see Section
11.2 Adjusting Crotch Strap Length)
8. Check that the straps are not twisted and
lie flat over the shoulders. Check that the
harness is secure by pulling up and forward
on the straps.
9. Connect the Harness Clip and position
the Harness Clip at the middle of the
child’s chest, level with the armpits.
(Fig 47-1)
10. The Crotch Strap should be adjusted
so that a gap of 1/2” to 1” is present
between the ears of the buckle and
the top of child’s thigh (Fig 47-2),
disregarding any clothing or diaper.
11. Tighten the harness straps to snugly
adjust harness around child by pulling
the Harness Adjuster Strap at the front
of the Car Seat as shown. (Fig 47-3)
12. Make sure the straps are flat and snug
against the child’s shoulders and thighs.
NOTE: A snug strap should not allow any
slack. It lies in a relatively straight line
11.0
Securing Child with Built-in Safety Harness
11.0
Securing Child with Built-in Safety Harness
without sagging. It does not press on the child’s flesh or
push the child’s body into an unnatural position.
Removing Your Child from Built-in Safety Harness
1. Open Harness Clip by pressing button and sliding apart.
2. Unbuckle the Harness Buckle by pressing the red button.
3. Press the Harness Adjuster Button and pull outward on the
straps to loosen.
4. Slide the harness straps off the child’s shoulders and arms.
5. Remove your child.
11.2 Adjusting the Crotch Strap Length
1. Remove either the Cup Holder or the
Game Holder to free the Seat Pad from
the seat shell. The Cup/Game Holders
are removed by pressing in the retainer
button and pulling up on the holder.
(Fig 48-1)
2. Pull back the Seat Pad from the seat
shell to reveal the Crotch Strap cavity.
3. You will see the Crotch Strap anchor
clip riding in a slot in the Crotch Strap
47-3
47-1
47-2
48-1
thigh
buckle