R&M Materials Handling ELECTRIC CHAIN HOISTS LoadMate Chain Hoist LM 10 Stepless - Manual (Page 36)

LM10 STEPLESS I&M MANUAL/EN/11.30.2010
36/99
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
Table 10. Electromagnetic Compatibility (EMC)
Declaration of conformity With the declaration of conformity the manufacturer informs that device is
manufactured to fulfill required EMC standards.
CE-mark The CE marking is a declaration by a manufacturer or importer located in the
European Economic Area that a product complies with the safety and health
requirements of the directive in question. The manufacturer demonstrates for the
authorities that the product complies with the safety requirements within the EU.
Environments Immunity and emission requirements are divided in two levels in the product
standard according to the environments.
First environment means environment that
includes domestic premises and also
establishments directly connected to a low-
voltage power supply network.
PDS
Second environment means environment that
includes all establishments other than those
directly connected a low-voltage power supply
network
PDS
7.5.6.1 EMC levels
Three kinds of EMC levels are available in D2S INVERTER product family, they are S, N and 0 level.
S-level: No manufacturer’s EMC solution is adopted and products will be used in other market
areas than European Union (EU) when local power supply system is the grounded network.
N-level: Manufacturer’s EMC solution is adopted to fit for Second Environment and products will be
used in EU when local power supply system is the grounded network.
0-level: No manufacturer’s EMC solution is adopted, products can be used in either EU or other market
areas when local power supply system is the non-grounded network.
7.5.6.2 Fulfilled EMC-standards
Immunity All D2S INVERTER products fulfill the immunity requirements defined in the EN
61800-3 Amendment 11 (2000) for the second environment.
Emissions D2S INVERTER - N level products fulfill the emission requirements (lower than
specification) of the EN 61800-3 A11 2000 for the second environment.
D2S INVERTER - 0 level products fulfill the emission requirements (they might
exceed the limit of N level products) of the EN 61800-3 A11 2000 for the second
environment
m
CAUTION: The involved products are designed for Second Environment (Industrial
Environment) only. The disturbances emitting from the basic products are not filtered to the
required level of residential, commercial and light industrial (e.g. offices, gasoline station,
retailer shops, etc.) environment (First Environment). In this sense, these products should
not be used in First environments. If you still want to use them in First environments,
additional requirements are needed, please contact
R&M MATERIALS HANDLING, INC.
m
CAUTION: EMC filters in N level products might cause disturbances on fault (leakage)
current relay